Standards Division
RENEWAL OF UNLIMITED PETROLEUM DEVICE
TECHNICIAN LICENSE
You must submit the renewal form to renew your
unlimited Petroleum Device Technician License each year. It
is important that you take immediate action in order to have
your registration renewed prior to December 31 of each year.
The following steps should be followed in completing the renewal
form for each applicant.
1. Fill in or correct (if necessary) your complete
mailing address, including zip code.
2. Fill in or correct (if necessary) employment
information, including company name, mailing address and zip
code.
3. Write in the state, date (month, day, and
year), and test number of the latest calibration for your
test measure or prover in the space provided.
Note: Your five-gallon test measure(s)
must have been tested on or after October 1 of the year
prior to the new license year.
Large provers for terminal meters must have been tested
within the last 36 months.
Dynamic small volume provers (SVPs) must have been tested
within the last 12 months.
4. If your test measure or prover was not tested by North
Carolina, enclose a copy of the test report from the state
where it was tested. This information must be included
before your license can be processed.
5. Sign the renewal form where the applicant's signature
is requested.
6. Enclose with your renewal form a lead and wire seal that
is embossed with your three (3) initials on one side and the
last two digits of the year of the license, for example, 09,
for 2009, on the other.
Your application cannot be processed until we receive
this seal. Therefore, we suggest that you immediately
order a die (embossed seal) for your hand sealer from the
stamp and die or petroleum equipment dealer of your choice.
7. Return the completed renewal form to:
NCDA & CS
Standards Laboratory
1051 Mail Service Center
Raleigh, NC 27699-1051
RENEWAL OF LIMITED PETROLEUM
DEVICE TECHNICIAN LICENSE
You must submit the renewal form to renew your
Limited Petroleum Device Technician License
each year. (This license is for those who service LP-Gas meters
but do not calibrate them.) It is important that you take
immediate action in order to have your registration renewed
prior to December 1 of each year. The following steps should
be followed in completing the renewal form for each applicant.
1. Fill in or correct (if necessary) your complete
mailing address, including zip code.
2. Fill in or correct (if necessary) employment
information, including company name, mailing address and zip
code.
3. Sign the renewal form where the applicant's
signature is requested.
4. Enclose with your renewal form a lead and
wire seal that is embossed with your initials (three letters)
on one side and the last two digits of the year of the license,
for example, 09, for 2009, on the other. Your application
cannot be processed until we receive this seal. Therefore,
we suggest that you immediately order a die (embossed seal)
for your hand sealer from the stamp and die or petroleum equipment
dealer of your choice.
5. Return the completed renewal form to:
NCDA & CS
Standards Laboratory
1051 Mail Service Center
Raleigh, NC 27699-1051
Last updated
July 14, 2009
|
